Clyde Building
Inspections

Defect Investigation Reports in Clyde

When your builder says a crack, a stain or a finish is within tolerance and you are not convinced, we inspect it, measure it and write down what the standard actually requires.

  • Item by item against the standard
  • Photographed and measured
  • Written for you and the builder
  • Names the clause or tolerance
  • Turnaround within 24 hours
  • Covers workmanship and weatherproofing
  • Upgradeable to an expert witness report
  • Inspector available to discuss
Get a quoteLeave your details and we will call you back.

No obligation. We use your details for your quote and may contact you about it even if you don't finish.

Fully licensed & accredited

What is included

What is included in a Clyde defect investigation report

A defect investigation is measured against the Guide to Standards and Tolerances 2015, the National Construction Code and ABCB Housing Provisions, AS 3700 for masonry, AS 3740 for wet areas and your contract drawings and specification.

Crack mapping

  • Width gauge on each crack
  • Crack direction recorded
  • Damage category per AS 2870
  • Veneer versus plaster cracks

Slab and floor levels

  • Floor levels surveyed room to room
  • Doors dropping on hinges
  • Gaps opening at cornices
  • Tile cracking across rooms

Leaks and damp tracing

  • Meter readings on a grid
  • Water staining traced
  • Damp at skirting height
  • Condensation or a leak

Wet area failures

  • Leaking shower recess
  • Tiles lifting or drummy
  • Water past the screen
  • Damp outside the bathroom

Roof and upper storey

  • Box gutter overflow signs
  • Upper wall flashings
  • Cracked ridge pointing
  • Valley iron laps

Clay soil and site water

  • Ponding beside the slab
  • Garden beds over slab edge
  • Downpipes not connected
  • Ag drain outlet blocked

Facade and cladding

  • Render cracking at sheet joints
  • Missing control joints
  • Weep holes rendered over
  • Sill and head flashings

Documents gathered

  • Building contract terms
  • Soil and footing reports
  • Warranty period dates
  • Emails with the builder

What happens next

  • Notice to the builder
  • Rectification scope in plain words
  • BPC dispute resolution path
  • Expert witness report if VCAT

36 checkpoints across 9 areas on a standard Clyde defect investigation report. We inspect what can be reached safely on the day. Anything locked, covered or blocked by stored goods is recorded as not inspected rather than passed.

Sample findings

Sample defects found during our defect investigations near Clyde

These findings come from an investigation report in Berwick, in the same City of Casey.

Brick window sills built with insufficient projection to throw water clear, found during a defect investigation in Berwick
Brick window sills built with insufficient projection to throw water clear
Insufficient waterproof membrane coverage and bandage at the wall junction, found during a defect investigation in Berwick
Insufficient waterproof membrane coverage and bandage at the wall junction
Balustrade glass not installed, leaving no fall protection at the edge, found during a defect investigation in Berwick
Balustrade glass not installed, leaving no fall protection at the edge
Rust staining bleeding through the rendered finish in several places, found during a defect investigation in Berwick
Rust staining bleeding through the rendered finish in several places
Poor brickwork workmanship at the front entry, found during a defect investigation in Berwick
Poor brickwork workmanship at the front entry
Voids and imperfections left in the brick mortar joints, found during a defect investigation in Berwick
Voids and imperfections left in the brick mortar joints
Chipped and damaged face bricks across the elevation, found during a defect investigation in Berwick
Chipped and damaged face bricks across the elevation
Damage to the aluminium window frames in several locations, found during a defect investigation in Berwick
Damage to the aluminium window frames in several locations
Inconsistent mortar colouring across areas of the brickwork, found during a defect investigation in Berwick
Inconsistent mortar colouring across areas of the brickwork
Impact damage to the garage door noted for assessment, found during a defect investigation in Berwick
Impact damage to the garage door noted for assessment
Our building inspectors
Why Clyde owners choose us

Independent. Licensed. Insured.

  • Every Clyde report is written by the inspector who attended, not a call centre.
  • We inspect to AS 4349.1, AS 2870, AS 1684 and the Guide to Standards and Tolerances 2015.
  • Casey is an N2 wind area, so bracing and tie-down get checked against the engineering.
  • You get the inspector's mobile number to talk the findings through with your builder.
Guides

Defect Investigation Reports guides for Clyde

All guides →

Book defect investigation reports in Clyde

Instant online pricing for Clyde, or contact the booking team.

FAQ

Defect Investigation Reports in Clyde: common questions

Can I use a defect report at VCAT?

No. A defect investigation is written for you and your builder. The Building and Plumbing Commission dispute resolution service and VCAT need an expert witness report, written to the VCAT expert evidence practice note. We can upgrade the report if it gets that far.

What is not included in a defect investigation?

We do not carry out destructive investigation, provide engineering certification, take soil or geotechnical samples, or perform the rectification work. Where a finding needs an engineer, we say so in the report.

My builder says it is within tolerance. What then?

That is exactly what the report resolves. We measure the item and quote the clause and the number, so the conversation moves from opinion to the document you both signed up to.

Get a Free Quote